Glue+ type AC-I
Mortar that meets the requirements of ISO 14081, with characteristics typical internal resistance of coatings, except those used for: Saunas, grills, greenhouses and other special coatings. Composed of Portland cement, aggregates and special additives.
CONDITIONS OF FINISH: Parts of the ceramic coating must be clean and dry.
CAUTION: Parts of low absorption and larger than 45x45 cm formats should, even indoors, be settled with mortars added grip.
CONDITIONS OF BASE: Cured at least 14 days (masonry, plaster and screed) and 28 days (concrete), clean, dry, flat, and strong enough. If they have powder residue, oils or leftover paint make your cleaning so as not to interfere with bonding. If they have imperfections on the surface, they shall be repaired with a minimum of 48 hours before applying the coating. If the base does not present sufficient strength to eliminate it completely and redo it running 14 days after coating.
TOOLS AND ACCESSORIES: plastic trough, trowel, steel trowel 6 x 6mm (smaller than 30x30 cm pieces) and 8 x 8 mm (larger than 30x30 cm pieces) with less than 1mm wear on the teeth, a container for action, hammer rubber, plastic spacers for the joints and personal protective equipment such as gloves, boots and óculos.PREPARO: Add water in the ratio indicated on the packaging. Knead vigorously to obtain a homogeneous, consistent and doughy paste. For at least 15 minutes (aging time) before application. Mix again without adding water and use up to two hours after preparation.
APPLICATION: Use extending planer with the flat side on the SUPERMASSA approximately 4 mm above the base layer, and then forming splines on the toothed side. Lay the pieces not exceeding the time of 10 minutes per step. Press the pieces by hand or using the rubber hammer, completely crushing the cords SUPERMASSA and allowing a perfect adhesion to ceramics. In parts of the upper 30x30cm apply SUPERMASSA also on the back part size. After 01 hours make the initial cleaning using a clean, damp sponge. After setting away some parts and see if your back is 100% of your completed by Supermassa area. 72 hours after grout using grout SUPERMASSA with thick joints specified by the manufacturer of ceramics. 6 days after the settlement soak the coat with water and proceed to final cleaning of parts using superclean PARTS SPECIAL and a clean, damp sponge. Release to light traffic after 7 days and 14 days after normal traffic nesting.
Note .: never soaking the coating with water before aplicação.Nunca strands that are based on secos.Nunca add more water to a mortar or already mixed beyond the use period of 2 bases horas.Em very porous and lightly moisten the dried basis água.Observar with structural joints and movimentação.Utilizar skilled labor and under technical supervision.
Of 4-5 kg / m² for less than 30x30 cm pieces.
Of 7-9 kg / m² for larger pieces 30x30 cm
SAFETY: Keep out of reach of children and pets. In case of eye contact or accidental ingestion, seek medical advice immediately, taking this container.
STORAGE: About pallets in a covered, dry, airy location away 30 cm from the wall. The battery shall have a maximum height of 2 meters.
DEADLINE: Deadline for 240 days
Saco de 15 Kg
Now the chat!
Learn about our companies
© 2013 by SuperMassa. All rights reserved.
For technical support and financial affairs, open a ticket at our Customer Service by clicking here.
For sales questions, contact requests or suggestions, please complete the form below.